Windows 2008 server and 4320 error

General development discussion.

Moderators: Susan Smith, admin, Gabriel

Post Reply
gtisdale
Posts: 218
Joined: Sun Jun 07, 2009 7:54 am
Location: Concord, Massachusetts
Contact:

Windows 2008 server and 4320 error

Post by gtisdale »

I have installed a new server (Small Business Back Office 2011 that uses WIn Server 2008 as the underlying foundation)

I also am using BR 4.30+zla

Every moring when I first log on to a BR application from my 64 bit Vista workstation I get a 4320 error after BR loads and tries to run a program. If I wait 30 seconds (or so) and try again, it works great. However, if I do not use a BR application session for a while, like an hour or so, I often, although not always get the same error again. If this happens the other session that is open (I usually have two or three sessions running simultaneously on my desktop) returns an error saying that the WBSERVER file is incompatable. I then exit all sessions and restart at which point everything runs smoothly again.

The SYSERR$ message when the 4320 error occurs is "Network not available".

I recall that there were some problems with the 2008SERVER that were discussed a few years ago, but could not find the thread.

I did execute
I have run

Code: Select all

net config server /autodisconnect:-1
to try to disable the auto dissconnect feature of Windows

Does anyone have any insight into this problem?

FNGeorge
bluesfannoz
Posts: 291
Joined: Fri Jun 19, 2009 9:01 am
Location: Lawrence, Kansas
Contact:

Post by bluesfannoz »

I think you might have been on the right track with an autodisconnect causing the issue after a period of time.

You might check your network cards default power down settings.


Also have you disabled SMB2 on the Windows 2008 Server. We had lots of bizarre issues until we disabled it.

Here are the instructions I usually follow. I typically only do it on the server.


http://www.petri.co.il/how-to-disable-s ... -2008.htm#
Steve Koger
Computer Specialist
SEKESC-MACS Division
Mikhail
Posts: 87
Joined: Tue Jul 07, 2009 10:26 am
Location: Ukraine

Re: Windows 2008 server and 4320 error

Post by Mikhail »

When you all disabled SMB2, did you switch down to SMB 1.5? Or SMB 1.0? I seem to still have problems getting kicked out of BR with no error message even after switching from SMB 2 to SMB 1.5
bluesfannoz
Posts: 291
Joined: Fri Jun 19, 2009 9:01 am
Location: Lawrence, Kansas
Contact:

Re: Windows 2008 server and 4320 error

Post by bluesfannoz »

We just shutoff SMB2 as being available from the server and let Windows determine what SMB to use. You did reboot the server after turning off SMB2 and recreate shares after turning it off. Also remove and brserver/wbserver.dat files that were created when SMB2 was enabled.
Steve Koger
Computer Specialist
SEKESC-MACS Division
Post Reply